TEL: +86 571 56623320 EMAIL: [email protected]
|
Technical Q & A
SL5105Hu Human p-STAT3 Tyr705 ELISA WBC lysate protocol
|
| Product | Human Phosphorylated STAT3 (Tyr705) ELISA Kit |
| Cat. No. | SL5105Hu |
We plan to use this kit for acute myeloid leukemia (AML) research, with samples being peripheral blood from patients and the control group. We would like to inquire about the detailed protocol for detecting p-STAT3 Tyr705 in primary human peripheral blood leukocyte lysates, including: 1. leukocyte isolation method; 2. recommended cell number per sample and lysis buffer volume; 3. sonication lysis conditions (power, time, temperature); 4. recommended phosphatase inhibitors and preparation; 5. whether it has been validated in primary human leukocyte lysates; 6. whether results are normalized to cell number or total protein concentration; 7. storage conditions and maximum storage time of lysed samples.
1. Leukocyte isolation: Collect peripheral blood using heparin- or EDTA-containing anticoagulant tubes, dilute with PBS at an equal ratio, and slowly layer onto the upper layer of lymphocyte separation medium. Centrifuge at room temperature (or 4°C), and carefully aspirate the intermediate buffy coat layer (PBMC). Wash the cells twice with PBS containing 0.1% BSA and 2 mM EDTA (300g, 8 minutes, 4°C) to remove platelets and residual separation medium.
2. Cell number and buffer: The cell density should be no less than 1×10^6 cells/mL. The buffer is prepared with PBS containing 0.1% BSA and 2 mM EDTA.
3. Sonication lysis: Under ice-bath conditions, use a probe sonicator at a power of 10–12 W (or energy 20–30%), pulse mode (on 5 seconds, off 5 seconds), with a total sonication time of 15–30 seconds (can be divided into 3–5 rounds, 5–10 seconds each, with cooling in between).
4. Phosphatase inhibitors: Detection of p-STAT3 is highly dependent on maintenance of the phosphorylation state, and a cocktail containing tyrosine phosphatase inhibitors is required. Halt protease and phosphatase inhibitor cocktail (EDTA-Free) is recommended, containing sodium fluoride (Ser/Thr phosphatase inhibitor), sodium orthovanadate (tyrosine phosphatase inhibitor), sodium pyrophosphate, and β-glycerophosphate. It is usually a 100X concentrated solution; before use, add directly to 1x lysis buffer at 1:100 (i.e., add 10 μL per 1 mL lysis buffer).
5. Primary human leukocyte lysate testing: Cell lysates have been tested; in principle, the lysate of isolated leukocytes is similar to that of conventionally cultured cells, and both should be detectable.
6. Normalization: Results are normalized to total protein concentration.
7. Storage: Short-term storage: If the supernatant after lysis and centrifugation is to be tested within 24 hours, it can be temporarily stored at 4°C (sealed to prevent evaporation). Long-term storage: It must be aliquoted and stored at -80°C, avoiding repeated freeze-thaw cycles. Maximum storage time: For phosphorylated proteins, it is recommended to complete testing within 1-3 months.
· Sample type: Lysate of primary human peripheral blood leukocytes (isolated PBMC); the customer’s research background is peripheral blood from AML patients and controls.
· Other specifications: p-STAT3 Tyr705 detection; a cocktail containing tyrosine phosphatase inhibitors is required; sonication must be performed in an ice bath; results should be normalized to total protein concentration; phosphorylated proteins are recommended to be detected within 1-3 months.
+86 571 56623320
[email protected]
SUNLONG BIOTECH

Scan Wechat Qrcode
